Αντλίες

Lorentz PS600

Characteristics 

• Lift up to 600 feet (180 m) 
• Flow rate up to 43 gpm (11.0 m3/h)
• Simple installation 
• Maintenance-free 
• High reliability and life expectancy 
• Cost-effective pumping solution

Application 

• Drinking water supply
• Livestock watering 
• Pond management 
• Irrigation

PS600 Controller 

• One controller for array direct or battery powered operation, with system status indication
• Mounted above ground (no submerged electronic parts) 
• Two control inputs for well probe (dry run protection) and remote control (float or pressure switch)
• Automatic reset 20 minutes after low water protection engages
• Protected against reverse polarity, overload and high temperature 
• Speed control, maximum pump speed adjustable to reduce flow rate to approximately 30 % 
• Solar operation: integrated MPPT (Maximum Power Point Tracking)
• Battery operation: low voltage disconnect and restart after battery has recovered 
• Max. efficiency 92 % (motor + controller) 
• Enclosure: IP 54 (sealed, weatherproof)

Pump End (PE) 

• High life expectancy 
• Non-return check valve 
• Dry running protection (optional) 
• Material: stainless steel (AISI 316), rubber

For HR Pumps only 

• Helical rotor pump (positive displacement pump) 
• Two main parts only: stator and rotor, field serviceable 
• Stator: geometry made of abrasion resistant rubber 
• Rotor: stainless steel, hard chrome plated, abrasion resistant 
• More resistant to damage by sand than other pump types 
• Self-cleaning

Motor ECDRIVE 600 H/C 

• Brushless DC motor
• No electronics inside motor 
• Water filled 
• IP 68, pressure balanced, max. submersion unlimited 
• Dynamic slide bearings, material: carbon/ceramic 
• Wetted material: stainless steel (AISI 316), POM, rubber, cable drinking water approved

Motor ECDRIVE 600 H/C

• Brushless DC motor 
• No electronics inside motor 
• Water filled 
• IP 68, pressure balanced, max. submersion unlimited
• Dynamic slide bearings, material: carbon/ceramic
• Wetted material: stainless steel (AISI 316), POM, rubber, cable drinking water approved

Drop Pipe

• 11/4”, 11/2” or 2” NPT pump outlet. If water is dirty, consider a smaller size drop pipe to increase the flow velocity. This helps exhaust solid particles and prevent accumulation in the pipe. When considering reduced pipe size, consult a pipe sizing (friction loss) chart. Pipe can be of any standard material, rigid or flexible. A torque arrestor is not required.

Temperature Limits 

• Pump end, motor: water temperature up to +104 °F (+40 °C) 
• Specify temperature range on order
• Controller: ambient temperature -22 to +131 °F (-30 to +55 °C)

Warranty 

• 2 years manufacturer’s warranty against defects in material and workmanship